[Fix] Epson Aculaser C1100 Error E511

[Fix] Epson Aculaser C1100 Error e511 – For epson printer users, an Epson Aculaser C1100 error with E511 error code is common and this is very annoying and we can not print photos properly. Here are some ways to fix the E511 error.

Epson Aculaser C1100 Error E511 is usually marked with lights on the printer is flashing and error message appears on the computer that is “Service Required E511”. For us this problem was triggered by the black transfer belt on the photoconducter device being ‘off-centre’. It took some doing, yet I ultimately handled to move the belt to the left by a few milimeters and all functioned penalty.

Relocate the massive elastic band which runs throughout the photoconductor system sidewards (surrender rollers while pressing sidewards too) till it type of similarly overlaps the rollers hence enabling the little silver square to be effectively seen by it’s detector

Epson Aculaser C1100 Error e511

 

The Epson Aculaser C1100 Error E511 comes when you power up the printer. The paper to be published is fed past the direct exposure roller with a 21 centimeters large transportation rubber band. That the printer recognizes, also with smaller sized sheets, when a round is rum, there is a roughly 1x1cm big silver rectangular shape on the band, which is signed up by a reflector light obstacle. The sound of the “warm up” is the black rubber transfer belt on the Photo Conductor Unit spinning via one rev to look for a little silver square on the edge of the belt. You could transform the belt by hand to see this square.

If this square is not found, Epson will tell you to get rid of an otherwise fine PCU.

Solution:
a) Remove PCU and check the transfer belt for the square. Tidy to not using any alcohol.
b) check the sensor that reads this square – a little black oblong “camera” in the heart of the printer on the LHS. Clean.
c) If the square is damaged, replace with an item of tin aluminum foil. Superglue on carefully, making sure all the sides are glued yet.

You do not need to put the new square in specifically the same location, just over or below on the belt is great. Get rid of the direct exposure system (ceiling top (B)) and lay it down with the blue roller dealing with up and the blue arrowheads on both sides encountering you. The shaft of the setter roller is held on the appropriate side by a copper-colored sleeve. You could transform it 90 levels with a set of pliers and some power and you have actually gotten rid of the roller (mindful – do not touch the roller).

See also Epson 4180 Error Message